F200-25 3/8" Compressed Air Filter - 25 CFM

The Van Air F200-25-3/8-(*) Filter Housing is good for 25 SCFM at 100 PSIG and has 3/8" NPT connections. During checkout, please enter the required Filtration Grade (*) in the "Special Comments" section. The filtration grades are all the same price and included in the cost of the filter housing.

Van Air has specialized in compressed air purification for over 60 years. Our compressed air filters have become an industry leader in protecting compressed air dryers, equipment, instrumentation, and processes. Van Air F200 Series compressed air filter housings have set the bar in quality and efficiency to meet today's air filtration needs.

All Van Air F200 Series filter housings are cast aluminum and coated with an epoxy powder coating to resist corrosion. The filter head also includes a pop-up differential indicator as standard equipment. This differential indicator is used as a visual indicator of when the filter element needs to be changed. With 14 housing sizes, 9 types of filtration grades, and a maximum working pressure of 250 PSIG at 225° F, our F200 Series filters will satisfy the most unique and demanding needs.

Our F200 Series compressed air filter housings are capable of automatic or manual draining. All F200 Series housings are equipped with a ball type manual drain valve as standard equipment. However, a Van Air automatic drain valve can be installed to automatically drain the filter when needed. This will prevent the filter housing from flooding, causing filter element damage and contaminating the air system. Additional accessories for the F200 Series compressed air filter housings include other differential pressure indicators, wall mounting kits, and connector kits.

FLOW CAPACITIES - SCFM

SELECTING A FILTER

To select the appropriate filter, determine the following conditions regarding the filter installation site:

• Maximum flow rate
• Min. and Max. operating pressures
• Operating temperature
• Pipe size
• Degree of filtration desired
• Contaminants to be removed

Next, refer to the Flow Capacities chart above and locate the column with your lowest operating pressure. Then find the flow rate closest to, but greater than, that of your system. Finally, read across to the left-hand column to determine the filter model that will meet your needs.

You will now need to refer to the Filtration Grades chart, located on the next "Tab". Determine the element grade that meets your needs. Be sure that the maximum inlet temperature listed on the chart is sufficient for your operating conditions.

Refer to the Dimensions and Specifications chart on the last "Tab" above and locate the proper filter model number. Once you have located the model number within the chart, verfiy that the inlet and outlet connections are suitable for your piping. Also make sure that there will be adequate clearance for element replacement.

DIMENSIONS AND SPECIFICATIONS

* Insert appropriate filtration grades here.
¹ Flow is based on SCFM @ 100 PSIG @ 100° F.
² Weight includes housing and elements.
• Due to continuous improvement, dimensions and specifications may change without notice.
• Request certified drawing before pre-piping.

FILTRATION GRADES