The Van Air HL-9 Mini Heatless Regenerative Compressed Air Dryer is compact, simple to install, and easy to maintain. This mini regenerative air dryer can handle 9 SCFM at 100 PSIG and delivers a -40°F pressure dew point to protect equipment from the damaging and expensive effects of compressed air moisture. In critical applications, MHL Series dryers can deliver a -100°F pressure dew point.
Each MHL Series mini regen dryer has advanced purge savings capability to minimize the waste of valuable compressed air. When the dryer is wired directly to an air compressor pressure switch or to auxiliary contacts, the dryer purge valves will open/close in parallel with the loading/unloading of the air compressor or point-of-use process. Stored memory in the dryer controller resumes the dryer cycling at the point where it left off.
STANDARD EQUIPMENT
- Molecular Sieve desiccant
- Integrated cycle timer
- Control valves
- Tower pressure gauges
- Purge exhaust mufflers
- Visual moisture indicator
- 115V/1/50-60 Hz supply power
- Wall mounting brackets
REGENERATIVE DRYERS MUST HAVE CLEAN, OIL-FREE INLET AIR
Lubricated compressors: Dryer must be equipped with pre-filters to prevent desiccant contamination. An after-filter should be installed downstream of the dryer to prevent desiccant particle migration.
Non-lubricated compressors: A particulate or coalescing pre-filter is recommended to prevent pipe scale and dust from fouling the dryer. An after-filter must be installed downstream of the dryer to prevent desiccant particle migration.